27

ADC14155QML-SP

www.ti.com

SNAS378L – NOVEMBER 2008 – REVISED FEBRUARY 2019

Product Folder Links: ADC14155QML-SP

Submit Documentation Feedback

Copyright © 2008–2019, Texas Instruments Incorporated

10 Layout

10.1 Layout Guidelines

For best dynamic performance, the center die attach pad of the device should be connected to ground with low

inductive path.

Proper grounding and proper routing of all signals are essential to ensure accurate conversion. Maintaining

separate analog and digital areas of the board, with the ADC14155 between these areas, is required to achieve

specified performance.

The ground return for the data outputs (DRGND) carries the ground current for the output drivers. The output

current can exhibit high transients that could add noise to the conversion process. To prevent this from

happening, it is recommended to use a single common ground plane with managed return current paths instead

of a split ground plane. The key is to make sure that the supply current in the ground plane does not return under

a sensitive node (e.g., caps to ground in the analog input network). This is done by routing a trace from the ADC

to the regulator / bulk capacitor for the supply so that it does not run under a critical node.

Capacitive coupling between the typically noisy digital circuitry and the sensitive analog circuitry can lead to poor

performance. The solution is to keep the analog circuitry separated from the digital circuitry, and to keep the

clock line as short as possible.

The effects of the noise generated from the ADC output switching can be minimized through the use of 22-

Ω

resistors in series with each data output line. Locate these resistors as close to the ADC output pins as possible.

Since digital switching transients are composed largely of high frequency components, total ground plane copper

weight will have little effect upon the logic-generated noise. This is because of the skin effect. Total surface area

is more important than is total ground plane area.

Generally, analog and digital lines should cross each other at 90° to avoid crosstalk. To maximize accuracy in

high speed, high resolution systems, however, avoid crossing analog and digital lines altogether. It is important to

keep clock lines as short as possible and isolated from ALL other lines, including other digital lines. Even the

generally accepted 90° crossing should be avoided with the clock line as even a little coupling can cause

problems at high frequencies. This is because other lines can introduce jitter into the clock line, which can lead to

degradation of SNR. Also, the high speed clock can introduce noise into the analog chain.

Best performance at high frequencies and at high resolution is obtained with a straight signal path. That is, the

signal path through all components should form a straight line wherever possible.

Be especially careful with the layout of inductors and transformers. Mutual inductance can change the

characteristics of the circuit in which they are used. Inductors and transformers should not be placed side by

side, even with just a small part of their bodies beside each other. For instance, place transformers for the analog

input and the clock input at 90° to one another to avoid magnetic coupling.

The analog input should be isolated from noisy signal traces to avoid coupling of spurious signals into the input.

Any external component (e.g., a filter capacitor) connected between the converter's input pins and ground or to

the reference input pin and ground should be connected to a very clean point in the ground plane.

All analog circuitry (input amplifiers, filters, reference components, etc.) should be placed in the analog area of

the board. All digital circuitry and dynamic I/O lines should be placed in the digital area of the board. The

ADC14155 should be between these two areas. Furthermore, all components in the reference circuitry and the

input signal chain that are connected to ground should be connected together with short traces and enter the

ground plane at a single, quiet point. All ground connections should have a low inductance path to ground.