IP113F
Preliminary Data Sheet
1.
PIN Description (continued)
Pin no.
Label
Type
Description
LED pins used as initial setting mode during reset
29
X_EN
IPH
IEEE 802.3X enable on TP port and fiber port
1: enable (default),
0: disable
24
TP_FORCE
IPL
Local TP port auto negotiation enable
1: TP port supports auto-negotiation with limited capability
defined in SPEED_MODE and DUPLEX_MODE.
0: TP port supports auto-negotiation with 10M/100M, full/
half capability (default)
The default value may be updated by either programming
EEPROM register 3.5 or MII register 20.13.
38
SPEED_MODE
IPH
Local TP port speed
1: TP port has the 100Mb speed ability
0: TP port has the 10Mb speed ability only
It is valid only if TP_FORCE is enabled.
30
DUPLEX_MODE
IPH
Local TP port duplex
1: TP port has the Full duplex ability
0: TP port has the Half duplex ability only
It is valid only if TP_FORCE is enabled.
25
AUTO_SEND
IPL
Auto send the status to the remote IP113F
1: enable
0: disable (default)
36
FX_FULL
IPH
Set the duplex of fiber port
1: full duplex (default)
0: half duplex
3
AUTO_TEST
IPL
Auto loop back test
1: enable
When IP113F detects a low-to-high transition on this pin, it
will perform loop back test for once.
0: disable (default)
Confidential.
7/46
Aug. 20, 2003
Copyright © 2003, IC Plus Corp.
IP113F-DS-R02
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
