GP32SLASH2 datasheet(5/44 Pages) CLARKE

5 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

4. ALWAYS ground the generator before using it to maximise safety, see ‘Ground

The Generator’ section on pages 15.

5. ALWAYS use a ground fault circuit interrupter (GFCI) in highly conductive areas

such as metal decking or steel work. Extension cords with an in-line GFCI are

recommended for these operations.

ADDITIONAL SAFETY RULES FOR GENERATORS

1. ALWAYS ensure the applied load does not exceed the generator rating.

Overloading the generator is dangerous and could cause damage.

2. ALWAYS disconnect and switch off the generator when carrying out any

maintenance.

3. ALWAYS ensure the generator reaches operating speed before connecting a

load.

4. NEVER allow the generator to run out of fuel when a load is connected.

5. NEVER transport the generator with fuel in the tank.

6. DO NOT connect to a commercial or residential power supply; e.g. ring main.

7. DO NOT touch hot parts. This generator produces heat when running.

Temperatures near the exhaust can exceed 150°F/65°C. Allow the generator to

cool down after use before touching the engine or areas of the generator that

become hot during use.

8. If any part of the generator, electrical device or power cable is broken, damaged

or defective, make sure it is repaired or replaced before using. Service or repair of

the generator should only be performed by a qualified technician.

9. NEVER modify the generator in any way. Modifying or using the generator for any

other purpose for which it is not designed may result in serious injury, machine

damage and voiding of the warranty.

10. ALWAYS turn off all connected electrical devices before stopping the generator.

11. ALWAYS turn the engine switch to the ‘OFF’ position when the engine is not

running.

12. NEVER carry or lift the generator using the handle assembly.

GP32/2 Datasheet(PDF) 5 Page - Clarke International