GP32SLASH2 datasheet(17/44 Pages) CLARKE

17 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

3. Turn the FUEL SWITCH to the

‘ON’ position as shown.

After completing steps 1 to 3, there are three ways to start the generator, either by

Electric One Button Start, Remote Control or Manual Recoil Start, as follows:

ELECTRIC ONE BUTTON START & REMOTE CONTROL

1. Hold down the ENGINE START/STOP button for 5

seconds.

NOTE: If the engine does not start, release the

button, wait 10 seconds and try again.

Keeping the button compressed for too long

can damage the starter.

NOTE: If you have repeated failed attempts to start

the engine, please consult the

troubleshooting guide on pages 28-29.

2. Alternatively, hold down the ENGINE START button

on the remote control for 5 seconds.

3. Allow the generator to run for several minutes before attempting to connect any

electrical devices. This allows the generator to stabilise its speed and temperature.

MANUAL RECOIL START

NOTE: Use the Recoil Starter when the battery voltage is too low to turn the

starter motor.

GP32/2 Datasheet(PDF) 17 Page - Clarke International