GP32SLASH2 datasheet(13/44 Pages) CLARKE

13 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

3. Using the oil funnel or appropriate dispenser, slowly

add oil as shown, being careful not to overfill the unit.

Fill the crankcase to the upper fill line so you can

visually see the oil coming halfway up the oil fill

threads.

4. Refit the oil dipstick and firmly tighten it. Wipe clean

any spilled oil.

NOTE: Used engine oil should be

disposed of at an approved

disposal site. See local authority

recycling for more information.

For subsequent operation, the oil level should be checked before each use, or after

every 8 hours of operation. The generator is equipped with a low oil sensor and will not

start without a sufficient amount of oil.

TO CHECK OIL LEVEL (BEFORE EVERY SUBSEQUENT START)

1. Place the generator on a level surface. Make sure the

engine is OFF before adding or checking oil.

2. Open the oil access cover. Remove and wipe the

dipstick with a clean rag.

3. Insert the dipstick into the oil fill without screwing it in.

Remove the dipstick and check the oil mark.

4. If the oil mark covers less than one half of the dipstick,

slowly add oil until the oil mark reaches to the top of

the dipstick (or when you can see the oil coming

halfway up the oil fill threads).

5. Wipe clean any oil leaks and firmly tighten the dipstick.

Reinstall the oil access cover.

STEP 2 - ADD/CHECK FUEL

Use only fresh (within 30 days from purchase), lead-free petrol with a minimum of 87

(E10) octane rating. The generator performs best with ethanol-free petrol. DO NOT use

petrol with over 10% ethanol. The capacity of the fuel tank is 26 Litres

GP32/2 Datasheet(PDF) 13 Page - Clarke International