GP32SLASH2 datasheet(18/44 Pages) CLARKE

18 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

1. Pull the Starter Grip lightly until

you feel resistance; then pull

briskly in the direction of the

arrow as shown.

NOTE: DO NOT allow the grip to

snap back after starting;

return it gently to its

original position.

2. Allow the generator to run for several minutes before attempting to connect any

electrical devices. This allows the generator to stabiles its speed and temperature.

SHUTTING OFF THE GENERATOR

WARNING: ALLOW THE GENERATOR TO COOL DOWN BEFORE TOUCHING

AREAS THAT BECOME HOT DURING USE.

CAUTION: ALLOWING PETROL TO SIT IN THE FUEL TANK FOR LONG

PERIODS OF TIME CAN MAKE IT DIFFICULT TO START THE GENERATOR IN

THE FUTURE. NEVER STORE THE GENERATOR FOR EXTENDED PERIODS OF

TIME (OVER 2 MONTHS) WITH FUEL IN THE TANK. REFER TO ‘STORING THE

GENERATOR’ ON PAGE 25

1. Turn off all electrical devices prior to unplugging them from the generator.

Unplugging running devices can cause damage to the generator.

2. Allow the generator to run at no

load for a few minutes to

stabilise the internal

temperature.

3. Turn the ‘MAIN SWITCH’ to the

‘OFF’ position.

4. Turn the FUEL switch to the

‘OFF’ position.

GP32/2 Datasheet(PDF) 18 Page - Clarke International