GP32SLASH2 datasheet(22/44 Pages) CLARKE

22 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

TO INSPECT AND CLEAN THE SPARK ARRESTOR:

1. Remove the left maintenance cover, then

loosen the jubilee clip holding the arrestor

cover in place and remove the arrestor

from its housing.

2. Use a brush to remove carbon deposits

from the spark arrestor screen. Be careful

to avoid damaging the screen. The spark

arrestor must be free of breaks and tears.

Replace the spark arrestor if it is damaged.

3. Install the spark arrestor in the reverse

order of removal.

DRAINING THE FUEL TANK/CARBURETTOR

To help prevent gum deposits in the fuel system, drain the fuel from the tank and

carburettor before storing.

TO DRAIN THE FUEL TANK & CARBURETTOR:

1. With the help of another person, place the generator on an elevated platform such

as a table or workbench.

TO DRAIN THE FUEL TANK

1. Remove the fuel tank cap and fuel strainer.

2. Using a petrol hand pump, empty the fuel tank into an approved petrol container.

Siphon the petrol by inserting the tip of the pump into the side of the pump guard.

NOTE: DO NOT use an electric pump

3. Reinstall the fuel strainer and replace the fuel tank cap.

GP32/2 Datasheet(PDF) 22 Page - Clarke International