ATmega88 datasheet(142/340 Pages) ATMEL

142 / 340 page

142

7530H–AVR–02/09

ATmega48/88/168 Automotive

Figure 15-6. Fast PWM Mode, Timing Diagram

The Timer/Counter Overflow Flag (TOV2) is set each time the counter reaches TOP. If the inter-

rupt is enabled, the interrupt handler routine can be used for updating the compare value.

In fast PWM mode, the compare unit allows generation of PWM waveforms on the OC2x pin.

Setting the COM2x1:0 bits to two will produce a non-inverted PWM and an inverted PWM output

can be generated by setting the COM2x1:0 to three. TOP is defined as 0xFF when WGM2:0 = 3,

and OCR2A when MGM2:0 = 7. (See Table 15-2 on page 146). The actual OC2x value will only

be visible on the port pin if the data direction for the port pin is set as output. The PWM wave-

form is generated by setting (or clearing) the OC2x Register at the compare match between

OCR2x and TCNT2, and clearing (or setting) the OC2x Register at the timer clock cycle the

counter is cleared (changes from TOP to BOTTOM).

The PWM frequency for the output can be calculated by the following equation:

The N variable represents the prescale factor (1, 8, 32, 64, 128, 256, or 1024).

The extreme values for the OCR2A Register represent special cases when generating a PWM

waveform output in the fast PWM mode. If the OCR2A is set equal to BOTTOM, the output will

be a narrow spike for each MAX+1 timer clock cycle. Setting the OCR2A equal to MAX will result

in a constantly high or low output (depending on the polarity of the output set by the COM2A1:0

bits.)

A frequency (with 50% duty cycle) waveform output in fast PWM mode can be achieved by set-

ting OC2x to toggle its logical level on each compare match (COM2x1:0 = 1). The waveform

generated will have a maximum frequency of f

oc2 = fclk_I/O/2 when OCR2A is set to zero. This fea-

ture is similar to the OC2A toggle in CTC mode, except the double buffer feature of the Output

Compare unit is enabled in the fast PWM mode.

TCNTn

OCRnx Update and

TOVn Interrupt Flag Set

Period

OCnx

(COMnx1:0 = 2)

(COMnx1:0 = 3)

OCRnx Interrupt Flag Set

fOCnxPWM

clk_I/O

256

⋅

---------------------

ATmega88 Datasheet(PDF) 142 Page - ATMEL Corporation