ATmega88 datasheet(233/340 Pages) ATMEL

233 / 340 page

233

7530H–AVR–02/09

ATmega48/88/168 Automotive

Several different scenarios may arise during arbitration, as described below:

• Two or more masters are performing identical communication with the same Slave. In this

case, neither the Slave nor any of the masters will know about the bus contention.

• Two or more masters are accessing the same Slave with different data or direction bit. In this

case, arbitration will occur, either in the READ/WRITE bit or in the data bits. The masters

trying to output a one on SDA while another Master outputs a zero will lose the arbitration.

Losing masters will switch to not addressed Slave mode or wait until the bus is free and

transmit a new START condition, depending on application software action.

• Two or more masters are accessing different slaves. In this case, arbitration will occur in the

SLA bits. Masters trying to output a one on SDA while another Master outputs a zero will lose

the arbitration. Masters losing arbitration in SLA will switch to Slave mode to check if they are

being addressed by the winning Master. If addressed, they will switch to SR or ST mode,

depending on the value of the READ/WRITE bit. If they are not being addressed, they will

switch to not addressed Slave mode or wait until the bus is free and transmit a new START

condition, depending on application software action.

This is summarized in Figure 19-22. Possible status values are given in circles.

Figure 19-22. Possible Status Codes Caused by Arbitration

20. Analog Comparator

The Analog Comparator compares the input values on the positive pin AIN0 and negative pin

AIN1. When the voltage on the positive pin AIN0 is higher than the voltage on the negative pin

AIN1, the Analog Comparator output, ACO, is set. The comparator’s output can be set to trigger

the Timer/Counter1 Input Capture function. In addition, the comparator can trigger a separate

interrupt, exclusive to the Analog Comparator. The user can select Interrupt triggering on com-

parator output rise, fall or toggle. A block diagram of the comparator and its surrounding logic is

shown in Figure 20-1

The Power Reduction ADC bit, PRADC, in “Power Reduction Register - PRR” on page 39 must

be disabled by writing a logical zero to be able to use the ADC input MUX.

Own

Address / General Call

received

Arbitration lost in SLA

TWI bus will be released and not addressed slave mode will be entered

A START condition will be transmitted when the bus becomes free

Arbitration lost in Data

Direction

Yes

Write

Data byte will be received and NOT ACK will be returned

Data byte will be received and ACK will be returned

Last data byte will be transmitted and NOT ACK should be received

Data byte will be transmitted and ACK should be received

Read

68/78

SLA

START

Data

STOP

ATmega88 Datasheet(PDF) 233 Page - ATMEL Corporation

ATmega88 Datasheet(HTML) 233 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL