DocID024847 Rev 2

9/26

AN4316

Monitoring STMTouch driver variables using STM Studio

25

Then, adjust the value range for each varviewer:

•

The Delta depends on the application sensitivity and can be positive or negative

•

The State varies from 0 to 19, for value meanings refer to TSL_StateId_enum_T in

tsl_types.h.

•

The reference depends on Cx/Cs

At this point, you have to connect the PC to your application with the selected binary code

downloaded in the microcontroller, through a USB cable and the appropriate hardware tool

(such as a ST-Link).

To start monitoring, click on the green arrow

or select the “Run/Start” menu.