TAS5076 datasheet(43/62 Pages) TI

43 / 62 page

System Procedures for Initialization, Changing Data Rates, and Switching Between Master and Slave Modes

SLES090A—November 2003—Revised January 2004

TAS5076

MCLK

MUTE

Terminal

ERR_RCVRY

Terminal

Change from a 96-kHz data rate

MCLK_IN = 24.576 MHz

Clock unstable during transition.

HIGH and LOW intervals < 20 ns

Change to a 48-kHz data rate

MCLK_IN = 12.288 MHz

Volume Ramp

Up 120 ms

Volume Ramp

Down 60 ms

ERR_RCVRY can be set at

any time within this interval

Wait a minimum of 100

µs after the

LOW to HIGH transition of RESET

Release ERR_RCVRY and

then MUTE when I2C

registers are programmed

> 5 ms

RESET

Terminal

< 2 ms

Set data rate and

restore other

via I2C

Figure 4−6. Changing the Data Sample Rate With an Unstable MCLK_IN Using the I2C

4.3

Changing Between Master and Slave Modes

The M_S terminal is set while the RESET terminal is active. Because this sequence employs the RESET

terminal the internal register settings are set to the default values.

Figure 4−7 shows the procedure to switch between master and slave modes and then restore the register

settings. In this example, the ERR_RCVRY terminal is used to hold off system re-initialization after RESET

is released. This permits the system controller to have as much additional time as necessary to restore the

Once the data rate is set, the ERR_RCVRY and MUTE terminal signals are set high and the system

re-initializes.

TAS5076 Datasheet(PDF) 43 Page - Texas Instruments

TAS5076 Datasheet(HTML) 43 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Datasheet Download

Link URL