P87LPC779 datasheet(38/74 Pages) PHILIPS

38 / 74 page

Philips Semiconductors

P87LPC779

CMOS single-chip 8-bit microcontroller

Product data

Rev. 02 — 03 May 2004

38 of 74

9397 750 13213

If the Brownout Detect function is not required in an application, it may be disabled,

thus saving power. Brownout Detect is disabled by setting the control bit BOD in the

AUXR1 register (AUXR1.6).

8.11.2

Power-on detection

The Power-on Detect has a function similar to the Brownout Detect, but is designed to

work as power comes up initially, before the power supply voltage reaches a level

where Brownout Detect can work. When this feature is activated, the POF ﬂag in the

PCON register is set to indicate an initial power up condition. The POF ﬂag will

remain set until cleared by software.

8.12 Power reduction modes

The P87LPC779 supports Idle and Power-down modes of power reduction.

8.12.1

Idle mode

The Idle mode leaves peripherals running in order to allow them to activate the

processor when an interrupt is generated. Any enabled interrupt source or Reset may

terminate Idle mode. Idle mode is entered by setting the IDL bit in the PCON register

(see Tables 29 and 30).

8.12.2

Power-down mode

The Power-down mode stops the oscillator in order to absolutely minimize power

consumption. Power-down mode is entered by setting the PD bit in the PCON register

(see Tables 29 and 30).

The processor can be made to exit Power-down mode via Reset or one of the

interrupt sources shown in Table 28. This will occur if the interrupt is enabled and its

priority is higher than any interrupt currently in progress.

In Power-down mode, the power supply voltage may be reduced to the RAM

keep-alive voltage VRAM. This retains the RAM contents at the point where

Power-down mode was entered. SFR contents are not guaranteed after VDD has

been lowered to VRAM, therefore it is recommended to wake up the processor via

Reset in this case. VDD must be raised to within the operating range before the

Power-down mode is exited. Since the Watchdog timer has a separate oscillator, it

may reset the processor upon overﬂow if it is running during Power-down.

Note that if the Brownout Detect reset is enabled, the processor will be put into reset

as soon as VDD drops below the brownout voltage. If Brownout Detect is conﬁgured

as an interrupt and is enabled, it will wake up the processor from Power-down mode

when VDD drops below the brownout voltage.

When the processor wakes up from Power-down mode, it will start the oscillator

immediately and begin execution when the oscillator is stable. Oscillator stability is

determined by counting 1024 CPU clocks after start-up when one of the crystal

oscillator conﬁgurations is used, or 256 clocks after start-up for the internal RC or

external clock input conﬁgurations.

P87LPC779 Datasheet(PDF) 38 Page - NXP Semiconductors

P87LPC779 Datasheet(HTML) 38 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

Datasheet Download

Link URL