Page 14

The TR-916-SC-PA module has been previously tested and received certification

as a modular product from the FCC. No further testing of the module is

necessary when compliant antennas are employed. The pre-certified status of

the module is valid only if all of the following are observed:

• No modifications to the module may be made.

• The module must utilize Linx antennas which have been previously tested with

the module and approved for FCC compliance.

• The pre-certified status applies only to the RF module. The user must

determine if additional certification or testing is required for peripheral circuitry.

• If the transceiver’s own label is not visible when installed inside another device

then the device must display an external label referring to the enclosed

module. The exterior label should appear as follows:

The product’s instruction manual must display the following statement:

This device contains

a previously certified

RF Transceiver module

FCC ID:OJM-TR-916-SC-PA

INSTRUCTION TO THE USER

This equipment contains an RF module which has been previously tested and

found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and if not installed and

used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This equipment has been certified to comply with the limits for a Class B

computing device, pursuant to FCC Rules. In order to maintain compliance with

FCC regulations, shielded cables must be used with this equipment. Operation

with non-approved equipment or unshielded cables is likely to result in

interference to radio and TV reception. The user is cautioned that changes and

modifications made to the equipment without the approval of manufacturer

could void the user's authority to operate this equipment.

LEGAL CONSIDERATIONS