WD1 datasheet(7/23 Pages) ETC

7 / 23 page

WD 1 (M) / WD 1000 (M)

7-18

5 Starting up the device

WARNING! Electric shock and risk of burns

Connecting the control unit incorrectly poses a risk of injury and

damage to the device. Risk of burns from the soldering tool while

the control unit is operating.

Read the enclosed instructions, the safety instructions included

in these Operating Instructions as well as the instructions for

your control unit all the way through and observe the specified

precautionary measures before operating the control unit.

Always place the soldering tool in the safety holder when not in

use.

1. Carefully unpack the device.

2. Connect the soldering tools as follows:

Insert the soldering tool with connector into the connecting socket

(9) on the control unit and turn clockwise to lock.

3. Place the soldering tool in the safety holder.

4. Check whether the mains supply voltage matches that indicated

on the rating plate and whether mains power switch (7) is off.

5. Connect the control unit to the mains supply (11).

6. Switch on the device at the mains power switch (7).

After the device has been switched on, the microprocessor carries

out a self-test in which all the display elements are briefly in

operation. The preset temperature (setpoint) and the temperature

unit (°C / °F) are then displayed briefly. The electronics automatically

switch to the actual value display. The symbol " " (17) appears on

the display (1) as an optical control check:

−

Continuous illumination indicates that the system is warming up.

−

Flashing light indicates that the preselected temperature has been

reached.

Note

Please refer to the accessories section on page 18 for a list of tools

that can be connected to the WD 1 (M) / WD 1000 (M).

WD1 Datasheet(PDF) 7 Page - List of Unclassifed Manufacturers