AMW136 datasheet(20/28 Pages) SILABS

20 / 28 page

Regulatory Certification

ADS-MWx36-102R • AMWx36 Datasheet

Page |15

June 26, 2019

7.2 Canada

The AMWx36 module has been certified for use in

Canada under Industry Canada (IC) Radio Standards

Specification (RSS) RSS-247 and RSSGen. Modular

approval permits the installation of a module in a host

device without the need to recertify the device.

7.2.1 Labeling and User Information

Requirements

Labeling Requirements for the Host Device (from Section

3.2.1, RSS-Gen): The host device shall be properly

labeled to identify the module within the host device.

The Industry Canada certification label of a module shall

be clearly visible at all times when installed in the host

device, otherwise the host device must be labeled to

display the Industry Canada certification number of the

module, preceded by the words “Contains transmitter

module”, or the word “Contains”, or similar wording

expressing the same meaning, as follows:

User Manual Notice for License-Exempt Radio Apparatus

(from Section 7.1.3 RSS-Gen): User manuals for license-

exempt radio apparatus shall contain the following or

equivalent notice in a conspicuous location in the user

manual or alternatively on the device or both:

Transmitter Antenna Notification (from Section 7.1.2

RSS-Gen): User manuals for transmitters shall display the

following notice in a conspicuous location:

The above notice may be affixed to the device instead of

displayed in the user manual.

Contains transmitter module IC: 11685A-B5BD9

This device complies with Industry Canada license-

exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not

cause interference, and (2) this device must accept

any interference, including interference that may

cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie

Canada applicables aux appareils radio exempts de

licence. L'exploitation est autorisée aux deux

onditions suivantes: (1) l'appareil ne doit pas

produire de brouillage, et (2) l'utilisateur de l'appareil

doit accepter tout brouillage radioélectrique subi,

meme si le brouillage est susceptible d'en

compromettre le fonctionnement.

Under Industry Canada regulations, this radio

transmitter may only operate using an antenna of a

type and maximum (or lesser) gain approved for the

transmitter by Industry Canada. To reduce potential

radio interference to other users, the antenna type

and its gain should be so chosen that the equivalent

isotropically radiated power (EIRP) is not more than

that necessary for successful communication.

Conformément à la réglementation d'Industrie Can-

ada, le présent émetteur radio peut fonctionner avec

une antenne d'un type et d'un gain maximal (ou

inférieur) approuvé pour l'émetteur par Industrie

Canada. Dans le but de réduire les risques de brouil-

lage radioélectrique à l'intention des autres utilisa-

teurs, il faut choisir le type d'antenne et son gain de

sorte

que

puissance

isotrope

rayonnée

équivalente (p.i.r.e.) ne dépasse pas l'intensité

nécessaire à l'établissement d'une communication

satisfaisante.

AMW136 Datasheet(PDF) 20 Page - Silicon Laboratories

AMW136 Datasheet(HTML) 20 Page - Silicon Laboratories

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Download

Link URL