M68HC05 datasheet(75/118 Pages) FREESCALE

75 / 118 page

SPI Registers

MC68HC05C9A Advance Information Data Sheet, Rev. 4.1

Freescale Semiconductor

SPIE — Serial Peripheral Interrupt Enable Bit

This read/write bit enables SPI interrupts. Reset clears the SPIE bit.

1 = SPI interrupts enabled

0 = SPI interrupts disabled

SPE — Serial Peripheral System Enable Bit

This read/write bit enables the SPI. Reset clears the SPE bit.

1 = SPI system enabled

0 = SPI system disabled

DWOM — Port D Wire-OR Mode Option Bit

This read/write bit disables the high side driver transistors on port D outputs so that port D outputs

become open-drain drivers. DWOM affects all seven port D pins together. This option is only available

when configured as a C9A.

1 = Port D outputs act as open-drain outputs.

0 = Port D outputs are normal CMOS outputs.

MSTR — Master Mode Select Bit

This read/write bit selects master mode operation or slave mode operation. Reset clears the MSTR bit.

1 = Master mode

0 = Slave mode

CPOL — Clock Polarity Bit

When the clock polarity bit is cleared and data is not being transferred, a steady state low value is

produced at the SCK pin of the master device. Conversely, if this bit is set, the SCK pin will idle high.

This bit is also used in conjunction with the clock phase control bit to produce the desired clock-data

relationship between master and slave. See Figure 10-1.

CPHA — Clock Phase Bit

The clock phase bit, in conjunction with the CPOL bit, controls the clock-data relationship between

master and slave. The CPOL bit can be thought of as simply inserting an inverter in series with the

SCK line. The CPHA bit selects one of two fundamentally different clocking protocols. When

CPHA = 0, the shift clock is the OR of SCK with SS. As soon as SS goes low, the transaction begins

and the first edge on SCK invokes the first data sample. When CPHA=1, the SS pin may be thought

of as a simple output enable control. See Figure 10-1.

SPR1 and SPR0 — SPI Clock Rate Selects

These read/write bits select one of four master mode serial clock rates, as shown in Table 10-1. They

have no effect in the slave mode.

$000A

Bit 7

654321

Bit 0

Read:

SPIE

SPE

DWOM

(C9A)

MSTR

CPOL

CPHA

SPR1

SPR0

Write:

Reset:

000001

U = Undetermined

Figure 10-4. SPI Control Register (SPCR)

M68HC05 Datasheet(PDF) 75 Page - Freescale Semiconductor, Inc

M68HC05 Datasheet(HTML) 75 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL