GWH4 datasheet(16/48 Pages) CLARKE

16 / 48 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

welding specification; after releasing the switch, the welding will be performed with

the normal welding specification given by the wire feeder; when the welding torch

switch is pressed again. After that, it will switch to the set arc welding specification

and stop welding when the switch is released.

(13) MACHINE CONNECTION TERMINAL "-" .

(14) MACHINE CONNECTION TERMINAL "+".

(15) FLY-JOINT FOR NEGATIVE AND POSITIVE SELECTION

(16) GAS CYLINDER RETAINER

A strap is also provided to retain the gas cylinder.

(17) SAFETY SWITCH

The main function of this switch is to automatically cut off the power when the

machine is overloaded or fails, so as to protect the personal safety of the user and the

important parts of the machine. Normally, this switch is moved up to the ON position.

The power switch on the local power distribution board (cabinet) should be used as

much as possible to start and stop the machine and do not use this switch as a power

switch.

(18) POWER CABLE

(19) GAS CONNECTOR

(20) FAN

Cools the heat-generating components in the machine

HIDDEN MENU SETTINGS

Press and hold the "Wire Inching"

and MIG/MAG MMA TIG Selection

Keys" at the same time and restore

the factory settings after 5 seconds.

GWH4 Datasheet(PDF) 16 Page - Clarke International