GWH4 datasheet(22/48 Pages) CLARKE

22 / 48 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

• We recommend you cut off and discard the first 10 cm of wire from the

spool to avoid any burrs and then straighten the next few centimetres of

wire to help with feeding.

2. Loosen the tensioning levers and pivot towards you.

3. Feed the wire through the guides,

over the drive roller and into the

torch liner.

• Push about 10-15 cm into the

torch liner.

4. Lower and reset the tensioning

handles.

• Tighten the tensioning handles

sufficiently to hold in position, but

do not fully tighten.

NOTE: Correct tension will allow the wire to feed into the torch liner smoothly

but will allow the drive roller to slip in the event of a blockage.

Adjust the pressure handles so that the pressing force is appropriate, the welding

wire is normally feeding and there is no slip on the wire feed rollers

1) The shaft of the wire spool is equipped with a damping adjustment mechanism

incorporating an adjustment bolt at its centre.

FITTING A WELDING ROD

Select the appropriate welding rod and insert it into the welding rod holder.

• It should be approximately the same thickness as the work-piece being

welded.

RECOMMENDED PRESSURES

Wire Dia

Reference Adjustment Scale

1.2

4 - 5

1.0

3 - 4

0.8

2 - 3

GWH4 Datasheet(PDF) 22 Page - Clarke International