MK68564 datasheet(18/46 Pages) STMICROELECTRONICS

18 / 46 page

character is loaded into the transmit buffer before

enabling the transmitter, that character will be sent

in place of the sync character(s).

Start of Transmission. Transmission will begin

with the loading of the first data character into the

transmit buffer, if the transmitter is already enabled.

For CRC to be calculated correctly on each mes-

sage, the CRC generator must be reset to all zeros

before the first data character is loaded into the

transmit buffer. This is accomplished by issuing a

Reset Tx CRC Generator command in the

Command Register.

Synchronous Transmit Characteristics. In all

Synchronous modes, characters are sent with the

least-significant bits first. All data is shifted out of the

Transmit Data pin (TxD) on the falling edge of the

Transmit Clock (TxC). The transmitter can transmit

from one to eight data bits per character. This re-

quires right-hand justification of data written to the

transmit buffer, if the selected word length is less

than eight bits per character. When the programmed

character length is six or seven bits, the unused bits

in the transmit buffer are ignored. If a word length of

five bits per character or less is selected, the data

loaded into the transmit buffer must be formatted as

described in the Transmit Control register part of the

The number of bits per character to be transmitted

can be changed on the fly. Any data written to the

transmit buffer, after the bits per character field is

changed, are affected by the change. The same is

true of any characters in the buffer at the time the

bits per character field is changed. The change in

the number of bits per character does not affect the

character in the process of being shifted out.

A transmitted message can be terminated by CRC

and sync characters, by sync characters only, or by

pad characters (replacing the sync character(s) in

the Sync Word Registers with pad characters). How

a message is terminated is controlled by the Tx Un-

derrun/EOM latch in Status Register 0.

Figure 11a : External Sync Timing.

Figure 11b : Simple External Sync Delay.

V000384

V000385

MK68564

18/46

MK68564 Datasheet(PDF) 18 Page - STMicroelectronics

MK68564 Datasheet(HTML) 18 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Datasheet Download

Link URL