WM8580 datasheet(20/103 Pages) WOLFSON

20 / 103 page

WM8580

Production Data

PD Rev 4.5 February 2008

Figure 8 3-Wire SPI Compatible Control Interface Non-Continuous Readback

2-WIRE SERIAL CONTROL MODE WITH READ-BACK

The WM8580 supports software control via a 2-wire read/write serial bus. Many devices can be

controlled by the same bus, and each device has a unique 7-bit address (see Table 10).

The controller indicates the start of data transfer with a high to low transition on SDIN while SCLK

remains high. This indicates that a device address and data will follow. All devices on the 2-wire bus

respond to the start condition and shift in the next eight bits on SDIN (7-bit address + Read/Write bit,

MSB first). If the device address received matches the address of the WM8580, the WM8580

responds by pulling SDIN low on the next clock pulse (ACK). If the address is not recognised, the

WM8580 returns to the idle condition and wait for a new start condition and valid address.

Once the WM8580 has acknowledged a correct address, the controller sends the first byte of control

data (REGA(6:0), i.e. the WM8580 register address plus the first bit of register data). The WM8580

then acknowledges the first data byte by pulling SDIN low for one clock pulse. The controller then

sends the second byte of control data (DIN (7:0),, i.e. the remaining 8 bits of register data), and the

WM8580 acknowledges by driving SDIN low.

The transfer of data is complete when there is a low to high transition on SDIN while SCLK is high.

After receiving a complete address and data sequence the WM8580 returns to the idle state and

waits for another start condition. If a start or stop condition is detected out of sequence at any point

during data transfer (i.e. SDIN changes while SCLK is high), the device returns to the idle condition.

Figure 9 2-Wire Serial Control Interface

The WM8580 has two possible device addresses, which can be selected using the CSB pin.

CSB STATE

DEVICE ADDRESS IN 2-

WIRE MODE

ADDRESS (X=R/W BIT)

X=0

X= 1

Low or Unconnected

0011010x

0x34

0x35

High

0011011x

0x36

0x37

Table 10 2-Wire MPU Interface Address Selection

WM8580 Datasheet(PDF) 20 Page - Wolfson Microelectronics plc