ATmega324P datasheet(211/377 Pages) ATMEL

211 / 377 page

211

7674F–AVR–09/09

ATmega164P/324P/644P

Figure 19-2. Data Validity

19.3.2

START and STOP Conditions

The Master initiates and terminates a data transmission. The transmission is initiated when the

Master issues a START condition on the bus, and it is terminated when the Master issues a

STOP condition. Between a START and a STOP condition, the bus is considered busy, and no

other master should try to seize control of the bus. A special case occurs when a new START

condition is issued between a START and STOP condition. This is referred to as a REPEATED

START condition, and is used when the Master wishes to initiate a new transfer without relin-

quishing control of the bus. After a REPEATED START, the bus is considered busy until the next

STOP. This is identical to the START behavior, and therefore START is used to describe both

START and REPEATED START for the remainder of this datasheet, unless otherwise noted. As

depicted below, START and STOP conditions are signalled by changing the level of the SDA

line when the SCL line is high.

Figure 19-3. START, REPEATED START and STOP conditions

19.3.3

Address Packet Format

All address packets transmitted on the TWI bus are 9 bits long, consisting of 7 address bits, one

READ/WRITE control bit and an acknowledge bit. If the READ/WRITE bit is set, a read opera-

tion is to be performed, otherwise a write operation should be performed. When a Slave

recognizes that it is being addressed, it should acknowledge by pulling SDA low in the ninth SCL

(ACK) cycle. If the addressed Slave is busy, or for some other reason can not service the Mas-

ter’s request, the SDA line should be left high in the ACK clock cycle. The Master can then

transmit a STOP condition, or a REPEATED START condition to initiate a new transmission. An

address packet consisting of a slave address and a READ or a WRITE bit is called SLA+R or

SLA+W, respectively.

SDA

SCL

Data Stable

Data Change

SDA

SCL

START

STOP

REPEATED START

STOP

START

ATmega324P Datasheet(PDF) 211 Page - ATMEL Corporation