ATmega324P datasheet(213/377 Pages) ATMEL

213 / 377 page

213

7674F–AVR–09/09

ATmega164P/324P/644P

19.3.5

Combining Address and Data Packets into a Transmission

A transmission basically consists of a START condition, a SLA+R/W, one or more data packets

and a STOP condition. An empty message, consisting of a START followed by a STOP condi-

tion, is illegal. Note that the Wired-ANDing of the SCL line can be used to implement

handshaking between the Master and the Slave. The Slave can extend the SCL low period by

pulling the SCL line low. This is useful if the clock speed set up by the Master is too fast for the

Slave, or the Slave needs extra time for processing between the data transmissions. The Slave

extending the SCL low period will not affect the SCL high period, which is determined by the

Master. As a consequence, the Slave can reduce the TWI data transfer speed by prolonging the

SCL duty cycle.

Figure 19-6 on page 213 shows a typical data transmission. Note that several data bytes can be

transmitted between the SLA+R/W and the STOP condition, depending on the software protocol

implemented by the application software.

Figure 19-6. Typical Data Transmission

19.4

Multi-master Bus Systems, Arbitration and Synchronization

The TWI protocol allows bus systems with several masters. Special concerns have been taken

in order to ensure that transmissions will proceed as normal, even if two or more masters initiate

a transmission at the same time. Two problems arise in multi-master systems:

• An algorithm must be implemented allowing only one of the masters to complete the

transmission. All other masters should cease transmission when they discover that they have

lost the selection process. This selection process is called arbitration. When a contending

master discovers that it has lost the arbitration process, it should immediately switch to Slave

mode to check whether it is being addressed by the winning master. The fact that multiple

masters have started transmission at the same time should not be detectable to the slaves, i.e.

the data being transferred on the bus must not be corrupted.

• Different masters may use different SCL frequencies. A scheme must be devised to

synchronize the serial clocks from all masters, in order to let the transmission proceed in a

lockstep fashion. This will facilitate the arbitration process.

The wired-ANDing of the bus lines is used to solve both these problems. The serial clocks from

all masters will be wired-ANDed, yielding a combined clock with a high period equal to the one

from the Master with the shortest high period. The low period of the combined clock is equal to

the low period of the Master with the longest low period. Note that all masters listen to the SCL

line, effectively starting to count their SCL high and low time-out periods when the combined

SCL line goes high or low, respectively.

Data Byte

Data MSB

Data LSB

ACK

789

Addr MSB

Addr LSB

R/W

ACK

SLA+R/W

ATmega324P Datasheet(PDF) 213 Page - ATMEL Corporation

ATmega324P Datasheet(HTML) 213 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL