Electronic Components Datasheet Search
  English  ▼

X  

PCF85134 Datasheet(PDF) 17 Page - NXP Semiconductors

Part # PCF85134
Description  Universal LCD driver for low multiplex rates
PDF  40 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Manufacturer  NXP [NXP Semiconductors]
Direct Link  http://www.nxp.com
Logo NXP - NXP Semiconductors

PCF85134 Datasheet(HTML) 17 Page - NXP Semiconductors

Back Button PCF85134 Datasheet HTML 13Page - NXP Semiconductors PCF85134 Datasheet HTML 14Page - NXP Semiconductors PCF85134 Datasheet HTML 15Page - NXP Semiconductors PCF85134 Datasheet HTML 16Page - NXP Semiconductors PCF85134 Datasheet HTML 17Page - NXP Semiconductors PCF85134 Datasheet HTML 18Page - NXP Semiconductors PCF85134 Datasheet HTML 19Page - NXP Semiconductors PCF85134 Datasheet HTML 20Page - NXP Semiconductors PCF85134 Datasheet HTML 21Page - NXP Semiconductors Next Button
Zoom Inzoom in Zoom Outzoom out
 17 / 40 page
background image
PCF85134_1
© NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 01 — 17 December 2009
17 of 40
NXP Semiconductors
PCF85134
Universal LCD driver for low multiplex rates
The following applies to Figure 10:
• In static drive mode the eight transmitted data bits are placed into row 0 of eight
successive 4-bit RAM words.
• In 1:2 multiplex mode the eight transmitted data bits are placed in pairs into
row 0 and 1 of four successive 4-bit RAM words.
• In 1:3 multiplex mode the eight bits are placed in triples into row 0, 1, and 2 of three
successive 4-bit RAM words, with bit 3 of the third address left unchanged. It is not
recommended to use this bit in a display because of the difficult addressing. This last
bit may, if necessary, be controlled by an additional transfer to this address, but care
should be taken to avoid overwriting adjacent data because always full bytes are
transmitted.
• In the 1:4 multiplex mode the eight transmitted data bits are placed in quadruples into
row 0, 1, 2, and 3 of two successive 4-bit RAM words.
7.11 Data pointer
The addressing mechanism for the display RAM is realized using the data pointer. This
allows the loading of an individual display data byte, or a series of display data bytes, into
any location of the display RAM. The sequence commences with the initialization of the
data pointer by the load-data-pointer command (see Table 9). Following this command, an
arriving data byte is stored at the display RAM address indicated by the data pointer. The
filling order is shown in Figure 10. After each byte is stored, the content of the data pointer
is automatically incremented by a value dependent on the selected LCD drive mode:
• In static drive mode by eight.
• In 1:2 multiplex drive mode by four.
• In 1:3 multiplex drive mode by three.
• In 1:4 multiplex drive mode by two.
If an I2C-bus data access terminates early, the state of the data pointer is unknown.
Consequently, the data pointer must be rewritten prior to further RAM accesses.
7.12 Subaddress counter
The storage of display data is conditioned by the content of the subaddress counter.
Storage is allowed only when the content of the subaddress counter match with the
hardware subaddress applied to A0, A1 and A2. The subaddress counter value is defined
by the device-select command (see Table 12). If the content of the subaddress counter
and the hardware subaddress do not match, then data storage is inhibited but the data
pointer is incremented as if data storage had taken place. The subaddress counter is also
incremented when the data pointer overflows.
In cascaded applications each PCF85134 in the cascade must be addressed separately.
Initially, the first PCF85134 is selected by sending the device-select command matching
the first device's hardware subaddress. Then the data pointer is set to the preferred
display RAM address by sending the load-data-pointer command.



Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40


Datasheet Download

Go To PDF Page


Link URL



Does ALLDATASHEET help your business so far?  [ DONATE ] 

About Alldatasheet   |   Advertisement   |   Contact us   |   Privacy Policy   |   Link to Datasheet    |   Link Exchange   |   Manufacturer List
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com