AS5262

Datasheet - Detailed Descr i p ti on

www.ams.com

Revision 1.1

11 - 36

8.2.3 Application Specific Programming of the Break Point

The break point BP can be programmed as well with 14 bits. This is important when the default transition point is inside the application range. In

such a case the default transition point must be shifted out of the application range. The parameter BP defines the new position.

Figure 6. Individual Programming of the Break Point BP

8.2.4 Full Scale Mode

Figure 7. Full Scale Mode

For simplification, Figure 7 describes a linear output voltage from rail to rail (0V to VDD) over the complete rotation range. In practice, this is not

feasible due to saturation effects of the output stage transistors. The actual curve will be rounded towards the supply rails (as indicated Figure 7).

0

100 % VDD

360