DOC7707 datasheet(92/307 Pages) ETC1

92 / 307 page

7707F–AVR–11/10

AT90USB82/162

clear

Clear TCNT0 (set all bits to zero).

clk

Timer/Counter clock, referred to as clk

T0 in the following.

top

Signalize that TCNT0 has reached maximum value.

bottom

Signalize that TCNT0 has reached minimum value (zero).

Depending of the mode of operation used, the counter is cleared, incremented, or decremented

at each timer clock (clk

T0). clkT0 can be generated from an external or internal clock source,

selected by the Clock Select bits (CS02:0). When no clock source is selected (CS02:0 = 0) the

timer is stopped. However, the TCNT0 value can be accessed by the CPU, regardless of

whether clk

T0 is present or not. A CPU write overrides (has priority over) all counter clear or

count operations.

The counting sequence is determined by the setting of the WGM01 and WGM00 bits located in

the Timer/Counter Control Register (TCCR0A) and the WGM02 bit located in the Timer/Counter

Control Register B (TCCR0B). There are close connections between how the counter behaves

(counts) and how waveforms are generated on the Output Compare outputs OC0A and OC0B.

For more details about advanced counting sequences and waveform generation, see “Modes of

Operation” on page 95.

The Timer/Counter Overflow Flag (TOV0) is set according to the mode of operation selected by

the WGM02:0 bits. TOV0 can be used for generating a CPU interrupt.

14.4

Output Compare Unit

The 8-bit comparator continuously compares TCNT0 with the Output Compare Registers

(OCR0A and OCR0B). Whenever TCNT0 equals OCR0A or OCR0B, the comparator signals a

match. A match will set the Output Compare Flag (OCF0A or OCF0B) at the next timer clock

cycle. If the corresponding interrupt is enabled, the Output Compare Flag generates an Output

Compare interrupt. The Output Compare Flag is automatically cleared when the interrupt is exe-

cuted. Alternatively, the flag can be cleared by software by writing a logical one to its I/O bit

location. The Waveform Generator uses the match signal to generate an output according to

operating mode set by the WGM02:0 bits and Compare Output mode (COM0x1:0) bits. The max

and bottom signals are used by the Waveform Generator for handling the special cases of the

extreme values in some modes of operation (“Modes of Operation” on page 95).

Figure 14-3 shows a block diagram of the Output Compare unit.

DOC7707 Datasheet(PDF) 92 Page - List of Unclassifed Manufacturers