TFP410

TI PanelBus DIGITAL TRANSMITTER

SLDS145A – OCTOBER 2001 – REVISED JANUARY 2002

6

POST OFFICE BOX 655303

–0.5 V to 4 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage, logic/analog signals

–0.5 V to 4 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

0

Ω to open circuit

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

300

Ω to open circuit

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

–65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Case temperature for 10 seconds

260

°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds

260

°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ESD protection, DVI pins

4 kV Human body model

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ESD protection, all other pins

2 kV Human body model

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

JEDEC latch-up (EIA/JESD78)

100 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

recommended operating conditions

MIN

NOM

MAX

UNIT

Supply voltage, VDD (DVDD, PVDD, TVDD)

3.0

3.3

3.6

V

Inp t reference oltage V

Low-swing mode

0.55

VDDQ/2‡

0.9

V

Input reference voltage, VREF

High-swing mode

DVDD

V

DVI termination supply voltage, AVDD (see Note 1)

DVI receiver

3.14

3.3

3.46

V

DVI Single-ended termination resistance, RT (see Note 2)

DVI receiver

45

50

55

Ω

TFADJ resistor for DVI-compliant V(SWING) range, R(TFADJ) 400 mV = V(SWING) = 600 mV

505

510

515

Ω

Operating free-air temperature range, TA

0

25

70

°C

‡ VDDQ defines the maximum low-level input voltage, it is not an actual input voltage.

NOTES:

1. AVDD is the termination supply voltage of the DVI link.

2. RT is the single-ended termination resistance at the receiver end of the DVI link.