preliminary

preliminary

MB4U

BiSS, SSI, PC-USB 2.0 ADAPTER

Rev C1, Page 12/16

Hex Editor Button and Selector Button Description

Area Select

Reads in sensor data

Read Register

Transfers configuration updates from the selected slave ID

Write Register

Transfers configuration updates to the selected slave ID

Save Reg. File

Saves sensor data to PC file

Load Reg. File

Loads sensor data from PC file

Fill

Fills all registers in the selected area with selected content or symbol

CRC Calculation

Calculates the CRC of a dedicated area

Figure 5: Register Access Screen (one tab each per slave ID)

Possible Errors

Main causes for errors:

• Using more than one software.

→

Please make sure that only one software is accessing the BiSS adapter at the same time.

• Insufficient power supply for all sensors attached.

→

The adapter will not respond if there is an overload due to the sensor(s) connected.

→

Please check wiring and use external power supply.

• Invalid transmission parameter settings.

→

Please check the sensor specific BiSS slave parameters, such as CRC polynomial etc.

→

Please check wiring and use external power supply.

• Invalid wiring

→

Please check wiring and use external power supply.