ML9060

¡ Semiconductor

11/17

During the 1/2 duty dynamic display mode of operation:

COM A and COM B change their states at every cycle of the COM OUT signal and repeat the

selected and non-selected modes always opposing each other in phase. A signal with the same

is output in the non-selected mode.

When COM A is in the selected mode (that is, COM B is in the non-selected mode), the segment

outputs (SEG1 to SEG160) output signals corresponding to the display data in the data latch A.

When COM B is in the selected mode (that is, COM A is in the non-selected mode), the segment

outputs (SEG1 to SEG160) output signals corresponding to the display data in the data latch B.

This is the power supply input pin for the logic circuits.

This is the power supply input pin for the LCD drivers.

• GND

This is the ground pin for all circuits.