7313 datasheet(4/17 Pages) PHOENIX

4 / 17 page

TP 04M, TP 06M, TP 06S, TP 07T

7313_en_03

PHOENIX CONTACT

4Mounting

The device enables quick and easy mounting from the rear.

Ideally, mounting should be in control panels with a plate

thickness of approximately 1 mm to 6 mm.

Push the device through the mounting cutout from the

front.

Figure 1

Mounting with mounting bracket

Place the mounting brackets in the appropriate slots (1)

and pull the brackets downwards until they snap into

place (2).

Secure the device using the threaded pins (3).

When mounting the touch panel, leave a

circumferential gap of at least 30 mm in order

to provide sufficient air circulation.

If the touch panel is mounted horizontally,

please note that additional heat sources may

cause a build-up of heat below the touch

panel.

Provide sufficient heat dissipation!

Please observe the permissible temperature

range specified in the technical data when

operating the device.

In order to ensure the specified degree of

protection, make sure that the grommet lies

flat against the mounting surface and the

threaded pins of the mounting brackets are

tightened uniformly.

7313 Datasheet(PDF) 4 Page - PHOENIX CONTACT