Type 8041

4 | 19

Visit product website 

1.

General technical data

Note:

If the device is mounted in a humid environment or outside, then the maximum voltage allowed is 35 V DC instead of 36 V DC.

Product properties

Material

Make sure the device materials are compatible with the fluid you are using.

Further information can be found in chapter “3.1. Bürkert resistApp” on page 8.

Further information on the materials can be found in chapter “3.2. Material specifications” on page 8.

Non wetted parts

Front panel film

Polyester

Cover

• Variant with flow sensor in PVDF: PC

• Variant with flow sensor in stainless steel: back PPA (glass fibre reinforced)

Housing

• Variant with flow sensor in PVDF: PC (glass fibre reinforced)

• Variant with flow sensor in stainless steel: back PPA (glass fibre reinforced)

Screw

Stainless steel

Union nut

• Variant with flow sensor in PVDF: PC

• Variant with flow sensor in stainless steel: back PPA (glass fibre reinforced)

Mounting ring

Polysulphone, glass fibre reinforced

Seal

NBR

Armature

Stainless steel 1.4404/316L (for flowmeter with clamp process connection, over the clamp)

Cable gland

PA with neoprene seal

Wetted parts

Clamp connection

Stainless steel 1.4404/316L

Sensor armature

• PVDF

• Stainless steel 1.4404/316L

Electrode holder

Only with variant with flow sensor in stainless steel: PEEK (conform to FDA)

Electrode

• Stainless steel 1.4404/316L

• Alloy C22

Earth ring

Only with variant with flow sensor in PVDF:

• Stainless steel 1.4404/316L

• Alloy C22

Seal

• For flowmeter with G 2" process connection:

– FKM (approved FDA)

– EPDM (conform to FDA)

• For flowmeter with clamp process connection:

(to be ordered separately, further information can be found in chapter “10.5. Ordering chart

accessories” on page 19.)

– EPDM

– FEP

Surface quality

For flowmeter with clamp process connection: Ra < 0.8 µm

Compatibility

• For flowmeter with G 2" process connection: Any pipe from DN 06…DN 400 which is fitted with

Bürkert Type S020 Insertion fitting with G 2" sensor connection.

• For flowmeter with clamp process connection: Any pipe from DN 32…DN 100 which is fitted with

Bürkert Type S020 Insertion fitting with clamp sensor connection.

For the selection of the nominal diameter of the Insertion fittings, see data sheet Type S020 .

Pipe diameter

• For flowmeter with G 2" process connection: DN 06…DN 400

• For flowmeter with clamp process connection: DN 32…DN 100

Dimensions

Further information can be found in chapter “4. Dimensions” on page 9.

Measuring element

Electrodes

Measuring principle

Electromagnetic

Measuring range

• Flow rate: 0.4…75000 l/min

• Flow velocity: 0.2…10 m/s