Type 8041

7 | 19

Visit product website 

2.

Approvals and conformities

2.1. General notes

• The approvals and conformities listed below must be stated when making enquiries. This is the only way to ensure that the product

complies with all required specifications.

• Not all available variants of the device can be supplied with the below mentioned approvals or conformities.

2.2. Conformity

In accordance with the Declaration of Conformity, the product is compliant with the EU Directives.

2.3. Standards

The applied standards which are used to demonstrate compliance with the EU Directives are listed in the EU-Type Examination Certificate

and/or the EU Declaration of Conformity.

2.4. Pressure Equipment Directive (PED)

The device conforms to article 4, paragraph 1 of the Pressure Equipment Directive (PED) 2014/68/EU under the following conditions:

Device used on a pipe

Note:

• The data in the table is independent of the chemical compatibility of the material and the fluid.

• PS = maximum admissible pressure (in bar), DN = nominal diameter of the pipe

Type of fluid

Conditions

Fluid group 1, article 4, paragraph 1.c.i

DN ≤ 25

Fluid group 2, article 4, paragraph 1.c.i

DN ≤ 32 or PS*DN ≤ 1000

Fluid group 1, article 4, paragraph 1.c.ii

DN ≤ 25 or PS*DN ≤ 2000

Fluid group 2, article 4, paragraph 1.c.ii

DN ≤ 200 or PS ≤ 10 or PS*DN ≤ 5000

2.5. North America (USA/Canada)

Approval

Description

Optional: UL Recognized for the USA and Canada

The products are UL Recognized for the USA and Canada according to:

• UL 61010-1

• CAN/CSA-C22.2 No. 61010-1

2.6. Foods and beverages/Hygiene

Conformity

Description

FDA

FDA – Code of Federal Regulations (valid for the variable code PL02, PL03)

Only devices with stainless steel or PVDF sensor and FKM or EPDM seals are compliant with the Code of Federal

Regulations published by the FDA (Food and Drug Administration, USA) according to the manufacturer‘s declaration.

EC Regulation 1935/2004 of the European Parliament and of the Council (valid for the variable code PL01,

PL02)

Only devices with stainless steel sensor and EPDM seals are compliant with EC Regulation 1935/2004/EC according

to the manufacturer‘s declaration.