AS1181 datasheet(44/92 Pages) AMSOSRAM

44 / 92 page

AS1181

Functional description

Datasheet • PUBLIC • Document Feedback

DS001139 • v3-00 • 2026-Apr-01

44 / 92

Note: After a direct CCC has been sent to the device a STOP condition needs to follow before

the next CCC can be sent.

7.4.4

Dynamically assigned addresses

The device supports I3C Dynamic Address Assignment, which is initiated by the external host

controller with the broadcast common command code 'Enter Dynamic Address Assignment'

(ENTDAA).

The device supports Dynamic Address Assignment in the condition where the external host

can overwrite the device statically assigned address using the common command code 'Set

Dynamic Address from Static Address' (SETDASA).

After an address is dynamically assigned, the device only responds to the newly assigned

address and no longer responds to the default target address. The dynamically assigned

address shall be used until the device is reset, at which point the device shall return to its

default target address.

7.4.5

Default I²C and I3C slave address

The default 7-bit I²C / I3C address is defined as follows. The ID1 and ID0 are input pins of the

device.

Table 11: Serial interface slave address configuration

ID1

ID0

Note that the I²C / I3C static address space is from 50h to 53h depending on the input levels

of ID1 and ID0.

AS1181 Datasheet(PDF) 44 Page - ams-OSRAM AG