23/26

For a detailed verification of the current version, the “EDITOR for LA series” software application can be used to check from the

PC.

If there is no personal computer, etc., available in its environment, contact your nearest Patlite Sales Representative and tell them

the status of LED tiers displayed to determine the current firmware version.

To exit from the “Version Confirmation” status, pressing the Multiple-function Button for about 3 seconds, or leaving it for 15

seconds untouched, will automatically cause it to return to it’s normal operation.

5.3.2.3. Product Initialization

The flashing speed of the white LED gradually becomes faster while holding the Multiple-function Button down until the White

LED is in its full flashing state. The first flashing lasts about 15 seconds before the flash rate increases, and by continuing to push

the Multiple-function Button, the White LED goes out after 10 seconds and Initialization (product returns to “Signal Tower” mode

and values are back to factory default) is completed.

Initialization

Complete

Continue pushing button until

initialization is complete.

About 15 sec.

About 5 sec.

About 5 sec.

The White LED ashing gradually becomes faster

When the White

LED goes out,

initialization is

complete.

Flashing

White

Slow-flashing

White

Fast-flashing

White

Note

• If the “Multiple-function” Button is released before initialization is completed, it returns to the “Signal Tower” mode.

• After pushing the “Multiple-function” Button, the standard time to completely return to factory default is 30 seconds.

• Initialization is only possible in the “Signal Tower” mode.

23/26