TMDS361 datasheet(27/42 Pages) TI

27 / 42 page

HPD Pins

1kW

TMDS361

HPD_SINK

VCC/5V_source

1 k

(internal

series resistor)

VCC

HPD_SINK

HPD[1:3]

HPD_SOURCE

OFF

VCC

HPD[1:3]

HPD_SOURCE

S0387-01

1kW

10kW

5V_Source (5VcomingfromHDMI source)

Layout Considerations

Using the TMDS361 in Systems with Different CEC Link Requirements

TMDS361

www.ti.com............................................................................................................................................................................................ SLLS919 – DECEMBER 2008

The HPD circuits are powered by the 3.3-V VCC supply. This provides maximum VOH = VCC and maximum VOL=

0.4-V output signals to the SOURCE with a typical 1-k

Ω output resistance. An external 1-kΩ resistor is not

needed here. The HPD output of the selected source port follows the logic level of the HPD_SINK input.

Unselected HPD outputs are kept low. When the device is in standby mode, all HPD outputs follow HPD_SINK.

If VOH greater than VCC is desired, then an external circuit as shown in Figure 33 can be used. In this case, the

max VOH can be equal to the 5 V coming from the HDMI source.

Figure 33. External Circuit to Drive 5-V VOH on HPD[1:3]

The high-speed differential TMDS inputs are the most critical paths for the TMDS361. There are several

considerations to minimize discontinuities on these transmission lines between the connectors and the device:

• Maintain 100-Ω differential transmission line impedance into and out of the TMDS361.

• Keep an uninterrupted ground plane beneath the high-speed I/Os.

• Keep the ground-path vias to the device as close as possible to allow the shortest return current path.

• Keep the trace lengths of the TMDS signals between connector and device as short as possible.

The TMDS361 supports a DTV with up to three HDMI inputs when used in conjunction with a signal-port HDMI

receiver. Figure 34 and Figure 35 show simplified application block diagrams for the TMDS361 in different DTVs

with different consumer electronic control (CEC) requirements. The CEC is an optional feature of the HDMI

interface for centralizing and simplifying user control instructions from multiple audio/video products in an

interconnected system, even when all the audio/video products are from different manufacturers. This feature

minimizes the number of remote controls in a system, as well as reducing the number of times buttons must be

pressed.

Submit Documentation Feedback

Product Folder Link(s) :TMDS361

TMDS361 Datasheet(PDF) 27 Page - Texas Instruments

TMDS361 Datasheet(HTML) 27 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Datasheet Download

Link URL