ATmega88 datasheet(210/340 Pages) ATMEL

210 / 340 page

210

7530H–AVR–02/09

ATmega48/88/168 Automotive

19.5.5

Control Unit

The Control unit monitors the TWI bus and generates responses corresponding to settings in the

TWI Control Register (TWCR). When an event requiring the attention of the application occurs

on the TWI bus, the TWI Interrupt Flag (TWINT) is asserted. In the next clock cycle, the TWI Sta-

tus Register (TWSR) is updated with a status code identifying the event. The TWSR only

contains relevant status information when the TWI Interrupt Flag is asserted. At all other times,

the TWSR contains a special status code indicating that no relevant status information is avail-

able. As long as the TWINT Flag is set, the SCL line is held low. This allows the application

software to complete its tasks before allowing the TWI transmission to continue.

The TWINT Flag is set in the following situations:

• After the TWI has transmitted a START/REPEATED START condition.

• After the TWI has transmitted SLA+R/W.

• After the TWI has transmitted an address byte.

• After the TWI has lost arbitration.

• After the TWI has been addressed by own slave address or general call.

• After the TWI has received a data byte.

• After a STOP or REPEATED START has been received while still addressed as a Slave.

• When a bus error has occurred due to an illegal START or STOP condition.

19.6

TWI Register Description

19.6.1

TWI Bit Rate Register – TWBR

• Bits 7..0 – TWI Bit Rate Register

TWBR selects the division factor for the bit rate generator. The bit rate generator is a frequency

divider which generates the SCL clock frequency in the Master modes. See “Bit Rate Generator

Unit” on page 209 for calculating bit rates.

19.6.2

TWI Control Register – TWCR

The TWCR is used to control the operation of the TWI. It is used to enable the TWI, to initiate a

Master access by applying a START condition to the bus, to generate a Receiver acknowledge,

to generate a stop condition, and to control halting of the bus while the data to be written to the

bus are written to the TWDR. It also indicates a write collision if data is attempted written to

TWDR while the register is inaccessible.

Bit

76543210

TWBR7

TWBR6

TWBR5

TWBR4

TWBR3

TWBR2

TWBR1

TWBR0

TWBR

Read/Write

R/W

Initial Value

00000000

Bit

76543210

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

TWCR

Read/Write

R/W

Initial Value

00000000

ATmega88 Datasheet(PDF) 210 Page - ATMEL Corporation

ATmega88 Datasheet(HTML) 210 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL