AD7710 datasheet(23/28 Pages) AD

23 / 28 page

AD7710

REV. F

–23–

Write Operation

Data can be written to either the control register or calibration

registers. In either case, the write operation is not affected by

the

DRDY line and the write operation does not have any effect

on the status of

DRDY. A write operation to the control register

or the calibration register must always write 24 bits to the

respective register.

Figure 13a shows a write operation to the AD7710 with

TFS

remaining low for the duration of the write operation. A0 deter-

mines whether a write operation transfers data to the control

remain valid for the duration of the serial write operation. As

before, the serial clock line should be low between read and

write operations. The serial data to be loaded to the AD7710

must be valid on the high level of the externally applied SCLK

signal. Data is clocked into the AD7710 on the high level of this

SCLK signal with the MSB transferred first. On the last active

high time of SCLK, the LSB is loaded to the AD7710.

Figure 13b shows a timing diagram for a write operation to the

AD7710 with

TFS returning high during the write operation

and returning low again to write the rest of the data word. Tim-

ing parameters and functions are very similar to that outlined for

Figure 13a, but Figure 13b has a number of additional times to

show timing relationships when

TFS returns high in the middle

of transferring a word.

Data to be loaded to the AD7710 must be valid prior to the

rising edge of the SCLK signal.

TFS should return high during

the low time of SCLK. After

TFS returns low again, the next bit

of the data word to be loaded to the AD7710 is clocked in on

next high level of the SCLK input. On the last active high time

of the SCLK input, the LSB is loaded to the AD7710.

t35

t33

SCLK (I)

SDATA (I)

A0 (I)

t32

MSB

LSB

t26

t27

t34

TFS (I)

t36

Figure 13a. External-Clocking Mode, Control/Calibration Register Write Operation

t35

SCLK (I)

SDATA (I)

TFS (I)

A0 (I)

MSB

BIT N

BIT N+1

t32

t26

t30

t27

t36

t35

t36

Figure 13b. External-Clocking Mode, Control/Calibration Register Write Operation

(

TFS Returns High During Write Operation)

AD7710 Datasheet(PDF) 23 Page - Analog Devices

AD7710 Datasheet(HTML) 23 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Download

Link URL