| Electronic Components Datasheet Search |
|
PC87393 Datasheet(PDF) 137 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
PC87393 Datasheet(HTML) 137 Page - National Semiconductor (TI) |
|
137 / 148 page ![]() 9.0 Device Characteristics (Continued) 137 www.national.com 9.2.5 Input, TTL Compatible with Schmitt Trigger Symbol: INTS 9.2.6 Output, PCI 3.3V Symbol: OPCI 9.2.7 Output, Totem-Pole Buffer Symbol: Op/n Output, Totem-Pole buffer that is capable of sourcing p mA and sinking n mA 9.2.8 Output, Open-Drain Buffer Symbol: ODn Output, Open-Drain output buffer, capable of sinking n mA. Output from these signals is open-drain and cannot be forced high. 9.2.9 Exceptions 1. All pins are back-drive protected, except for the output pins with PCI Buffer Type. 2. The following pins have a PU220 internal pull-up resistor and therefore have input leakage current to VDD: ACK, AFD_DSTRB, ERR, INIT, PE, SLIN_ASTRB, STB_WRITE. 3. The following pins have a PU25 internal pull-up resistor and therefore have input leakage current to VDD: GPIO40-47, GPIO30-37, GPIO20-27, GPIO10-17, GPIO00-07. 4. The following pins have a PD120 internal pull-down resistor and therefore have input leakage current to GND: BUSY_WAIT, PE, SLCT. 5. Output from SLCT, BUSY_WAIT (and PE if bit 2 of PP Confg0 Register is 0) is open-drain in all SPP modes, except in SPP Compatible mode when the setup mode is ECP-based FIFO and bit 4 of the Control2 parallel port register is 1. Otherwise, output from these signals is level 2. External 4.7 K Ω pull-up resistors should be used. Symbol Parameter Conditions Min Max Unit VIH Input High Voltage 2.0 5.51 1. Not tested. Guaranteed by design. V VIL Input Low Voltage −0.5 1 0.8 V IIL Input Leakage Current VIN =VDD 10 µA VIN =VSS −10 µA VH Input Hysteresis 250 mV Symbol Parameter Conditions Min Max Unit VOH Output High Voltage lout = -500 µA 0.9VDD V VOL Output Low Voltage lout =1500 µA 0.1 VDD V Symbol Parameter Conditions Min Max Unit VOH Output High Voltage IOH = −p mA 2.4 V VOL Output Low Voltage IOL = n mA 0.4 V Symbol Parameter Conditions Min Max Unit VOL Output Low Voltage IOL = n mA 0.4 V |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |