REV. 0

AD7927

–9–

Table I. Control Register Bit Functions

MSB

LSB

WRITE

SEQ

DONTC

ADD2

ADD1

ADD0

PM1

PM0

SHADOW

DONTC

RANGE

CODING

Bit

Mnemonic

Comment

11

WRITE

The value written to this bit of the Control Register determines whether the following 11 bits will be loaded

to the Control Register. If this bit is a 1, the following 11 bits will be written to the Control Register; if it is

a 0, then the remaining 11 bits are not loaded to the Control Register and it remains unchanged.

10

SEQ

The SEQ bit in the Control Register is used in conjunction with the SHADOW bit to control the use of the

sequencer function and access the Shadow Register. (See Table IV.)

9

DONTC

Don’t Care

8–6

ADD2–ADD0

These three address bits are loaded at the end of the present conversion and select which analog input channel

is to be converted in the next serial transfer, or they may select the final channel in a consecutive sequence

as described in Table IV. The selected input channel is decoded as shown in Table II. The address bits

corresponding to the conversion result are also output on DOUT prior to the 12 bits of data. (See the Serial

Interface section.) The next channel to be converted on will be selected by the mux on the 14th SCLK

falling edge.

5, 4

PM1, PM0

Power Management Bits. These two bits decode the mode of operation of the AD7927 as shown in Table III.

3

SHADOW

The SHADOW bit in the Control Register is used in conjunction with the SEQ bit to control the use of the

sequencer function and access the Shadow Register. (See Table IV.)

2

DONTC

Don’t Care

1

RANGE

This bit selects the analog input range to be used on the AD7927. If it is set to 0, the analog input range

will extend from 0 V to 2

(for the next conversion). For the 0 V to 2

0

CODING

This bit selects the type of output coding the AD7927 will use for the conversion result. If this bit is set to

0, the output coding for the part will be twos complement. If this bit is set to 1, the output coding from the

part will be straight binary (for the next conversion).

CONTROL REGISTER

The Control Register on the AD7927 is a 12-bit, write-only register. Data is loaded from the DIN pin of the AD7927 on the falling

edge of SCLK. The data is transferred on the DIN line at the same time that the conversion result is read from the part. The data

transferred on the DIN line corresponds to the AD7927 configuration for the next conversion. This requires 16 serial clocks for every

data transfer. Only the information provided on the first 12 falling clock edges (after

CS falling edge) is loaded to the Control Register.

MSB denotes the first bit in the data stream. The bit functions are outlined in Table I.

CODE

1.0

0

4096

0

–0.4

–0.8

–1.0

0.2

–0.2

–0.6

2048

0.6

TEMP = 25 C

0.4

0.8

2560

3072

3584

512

1024

1536

TPC 6. Typical INL

CODE

1.0

0

4096

0

–0.4

–0.8

–1.0

0.2

–0.2

–0.6

2048

0.6

0.4

0.8

2560

3072

3584

512

1024

1536

TEMP = 25 C

TPC 7. Typical DNL