LAN91C100FD datasheet(17/79 Pages) SMSC

17 / 79 page

FEAST Fast Ethernet Controller with Full Duplex Capability

SMSC DS – LAN91C100FD Rev. D

Page 17

Rev. 10/14/2002

PRELIMINARY

at 100 Mbps), while TXD3 carries the most significant bit of the nibble. TXEN100 and TXD0-TXD3 are

clocked by the LAN91C100FD using TX25 rising edges. TXEN100 goes inactive at the end of the packet

on the last nibble of the CRC.

During a transmission, COL100 might become active to indicate a collision. COL100 is asynchronous to

the LAN91C100FD’s clocks and will be synchronized internally to TX25.

Reception begins when RX_DV (receive data valid) is asserted. A preamble pattern or flag octet will be

present at RXD0-RXD3 when RX_DV is activated. The LAN91C100FD requires no training sequence

beyond a full flag octet for reception. RX_DV as well as RXD0-RXD3 are sampled on RX25 rising edges.

RXD0 carries the least significant bit and RXD3 the most significant bit of the nibble. RX_DV goes inactive

when the last valid nibble of the packet (CRC) is presented at RXD0-RXD3.

RX_ER might be asserted during packet reception to signal the LAN91C100FD that the present receive

packet is invalid. The LAN91C100FD will discard the packet by treating it as a CRC error.

When MIISEL=1, RXD0-RXD3 should always be aligned to packet nibbles, therefore, opening flag

detection does not consider misaligned cases. Opening flag detection expects the 5Dh pattern and will not

reject the packet on non-preamble patterns. When MIISEL=0 the opening flag detection expects a

"10101011" pattern and will use it for determining nibble alignment.

CRS100 is used as a frame envelope signal for the CSMA/CD MAC state machines (deferal and backoff

functions), but it is not used for receive framing functions. CRS100 is an asynchronous signal and it will be

active whenever there is activity on the cable, including LAN91C100FD transmissions and collisions.

Switching between the ENDEC and MII interfaces is controlled by the MII SELECT bit in the CONFIG

logic.

Note that given the modular nature of the MII, TX25 and RX25 cannot be assumed to be free running

clocks. The LAN91C100FD will not rely on the presence of TX25 and RX25 during reset and will use its

own internal clock whenever a timeout on TX25 is detected.

4.2.6

MII Management Interface Block

PHY management through the MII management interface is supported by the LAN91C100FD by providing

the means to drive a tri-statable data output, a clock, and reading an input. Timing and framing for each

management command is to be generated by the CPU.

4.2.7

Serial EEPROM Interface

This block is responsible for reading the serial EEPROM upon hardware reset (or equivalent command)

and defining defaults for some key registers. A write operation is also implemented by this block, that

under CPU command will program specific locations in the EEPROM. This block is an autonomous state

machine and controls the internal Data Bus of the LAN91C100FD during active operation.

LAN91C100FD Datasheet(PDF) 17 Page - SMSC Corporation