CS5920 datasheet(135/160 Pages) AMCC

135 / 160 page

S5920 – PCI Product

Revision 1.01 – November 28, 2005

AMCC Confidential and Proprietary

DS1596

135

Data Book

Figure 73. Active Mode PCI Write without PTADR#

When PTADR# is active (low), the S5920 will drive the

DQ[31:0] bus with the 32-bit PCI address regardless of

the PTMODE pin. To avoid contention on the DQ[31:0]

bus during PCI read cycles, the S5920 incorporates a

turnaround cycle before starting to drive the data

(DXFR# asser tion) . This is needed only when

PTADR# is enabled and when zero wait states are

programmed during a Pass-Thru read cycle. The cycle

immediately following the address cycle will be a turn-

around cycle as shown in Figure 13a.

If PTADR# is disabled, the DXFR# output will be

driven one clock cycle after PTATN# is valid (PTATN#

is not considered active until PTATN# is low and

PTWAIT# is high) regardless of the transfer being a

read or a write. Figure 13b shows a PCI read cycle

with PTADR# disabled.

Figure 13c shows a Pass-Thru write cycle with

PTADR# disabled.

Active mode Programmable Wait States

Bits 0,1,2 of the PTCR register control this feature.

Wait States are programmed on a per region basis.

For example: region one can be set for zero wait

states while other regions may have multiple wait

states programmed.

Wait state options are 0,1,2,...7 wait states. The S5920

will always count N wait states (N=0,1,..7) before com-

pleting the current data phase.

Figures 17, 18 and 19 show Pass-Thru transfers with

programmed wait states.

PTRDY#/PTWAIT#

In Active mode, the PTRDY#/PTWAIT# pin takes the

PTWAIT# function, which is the opposite function of

this pin when configured for passive mode. That is, if

the part is configured to operate in Active mode,

PTWAIT# asserted low means the Add-On wishes to

insert wait states.

Add-On peripherals are allowed to insert wait state

cycles at any time during an Active mode transfer.

When PTWAIT# has been sampled low, the S5920 will

tri-state its DQ[31:0] bus in order to allow other Add-

On devices to use the bus without contention.

Figure 74. Active Mode PCI Write with Add-On Initiated Wait States Using PTWAIT#

ADCLK

PTATN#

PTBURST#

PTNUM[1:0]

PTWR

PTBE[3:0]

DXFR#

DQ[31:0]

PTWAIT#

DATA

PTADR#

01b

234

ADCLK

PTATN#

PTBURST#

PTNUM[1:0]

PTWR

PTBE[3:0]#

DXFR#

DQ[31:0]

PTADR#

PTWAIT#

DATA

PTADDR

01b

CS5920 Datasheet(PDF) 135 Page - Applied Micro Circuits Corporation

CS5920 Datasheet(HTML) 135 Page - Applied Micro Circuits Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL