S29GL032A datasheet(63/95 Pages) SPANSION

63 / 95 page

September 10, 2007 S29GL-A_00_A11

S29GL-A

Data

She e t

10.3

Write Operation Status

The device provides several bits to determine the status of a program or erase operation: DQ2, DQ3, DQ5,

DQ6, and DQ7. Table 10.2 on page 68 and the following subsections describe the function of these bits. DQ7

and DQ6 each offer a method for determining whether a program or erase operation is complete or in

progress. The device also provides a hardware-based output signal, RY/BY#, to determine whether an

Embedded Program or Erase operation is in progress or is completed.

10.4

DQ7: Data# Polling

The Data# Polling bit, DQ7, indicates to the host system whether an Embedded Program or Erase algorithm

is in progress or completed, or whether the device is in Erase Suspend. Data# Polling is valid after the rising

edge of the final WE# pulse in the command sequence.

During the Embedded Program algorithm, the device outputs on DQ7 the complement of the datum

programmed to DQ7. This DQ7 status also applies to programming during Erase Suspend. When the

Embedded Program algorithm is complete, the device outputs the datum programmed to DQ7. The system

must provide the program address to read valid status information on DQ7. If a program address falls within a

protected sector, Data# Polling on DQ7 is active for approximately 1 µs, then the device returns to the read

mode.

During the Embedded Erase algorithm, Data# Polling produces a 0 on DQ7. When the Embedded Erase

algorithm is complete, or if the device enters the Erase Suspend mode, Data# Polling produces a 1 on DQ7.

The system must provide an address within any of the sectors selected for erasure to read valid status

information on DQ7.

After an erase command sequence is written, if all sectors selected for erasing are protected, Data# Polling

on DQ7 is active for approximately 100 µs, then the device returns to the read mode. If not all selected

sectors are protected, the Embedded Erase algorithm erases the unprotected sectors, and ignores the

selected sectors that are protected. However, if the system reads DQ7 at an address within a protected

sector, the status may not be valid.

Just prior to the completion of an Embedded Program or Erase operation, DQ7 may change asynchronously

with DQ0–DQ6 while Output Enable (OE#) is asserted low. That is, the device may change from providing

status information to valid data on DQ7. Depending on when the system samples the DQ7 output, it may read

the status or valid data. Even if the device completed the program or erase operation and DQ7 has valid data,

the data outputs on DQ0–DQ6 may be still invalid. Valid data on DQ0–DQ7 appears on successive read

cycles.

Table 10.2 on page 68 shows the outputs for Data# Polling on DQ7. Figure 10.3 on page 64 shows the Data#

Polling algorithm. Figure 16.8 on page 80 shows the Data# Polling timing diagram.

S29GL032A Datasheet(PDF) 63 Page - SPANSION