GWH3 datasheet(14/40 Pages) CLARKE

14 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

Loose items supplied include the following:

13. 1 x Hammer/brush

14. 1 x Face shield

15. 1x Spool of 0.6mm mild steel welding wire

16. 1x Spool of 0.9 mild steel welding wire

17. 1 x 0.6mm welding torch tip

18. 1 x 0.8mm welding torch tip (fitted)

19. 1 x 0.9mm welding torch tip

20. 1 x 0.6/0.8mm wire roller (fitted)

21. 1 x 0.9/1mm wire roller

22. 1 x torch wrench (for changing tips)

23. 1 x 520mm Gas hose

24. 1 x Gas bottle holder (2 pieces)

THE CONTROL FUNCTIONS

1. Power LED. When the power is switched on at the rear of the machine the switch

will be illuminated, as will the green ‘Power On’ LED.

2. Thermal overload LED. If the duty cycle is exceeded as a result of welding for

too long with a high current, the overload light will illuminate and the welder will

turn off. When the welder has cooled down (approx. 5 to 10 minutes), the power

will be restored and welding can recommence.

3. Wire speed /current control knob. A higher current requires a higher wire

speed. Wire speed should be set based upon the table on page 28.

4. Wire thickness selector switch. For use with MIG/Flux welding in one of three

positions (0.6, 0.8/0.9, 1.0).

5. MIG/MMA/LIFT TIG function selector switch for welding mode selection.

GWH3 Datasheet(PDF) 14 Page - Clarke International