GWH3 datasheet(16/40 Pages) CLARKE

Part #	GWH3

Description	MIG/MMA/TIG INVERTER WELDER

PDF	40 Pages

Scroll/Zoom	100%

Manufacturer	CLARKE [Clarke International]

Direct Link	https://www.clarkeinternational.com/

Logo

16 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

PREPARATION FOR USE

FITTING THE GAS BOTTLE HOLDER

IMPORTANT: Ensure that the

welder is not connected to the

mains supply before opening.

1. Open the side panel by pushing the

latch down and allowing the side

panel to drop down.

2. Remove any loose items that have

been transported inside.

3. Place the lower bottle bracket into

position and secure in place using the

2 screws provided.

4. Secure the top clip in place using the

screw provided.

5. Fit the gas cylinder to the rear of the machine. Install the pressure relief valve to

the gas cylinder and ensure it is tight to prevent leakage.

WARNING: NEVER OPERATE THIS MACHINE WITH THE SIDE

PANELS PARTIALLY OPENED OR REMOVED.

GWH3 Datasheet(PDF) 16 Page - Clarke International