GWH3 datasheet(17/40 Pages) CLARKE

17 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MOUNTING THE WELDING WIRE SPOOL

Select the appropriate wire diameter according to the welding process. After the wire

diameter is selected, check that the wire diameter matches the size of the wire

feeding wheel and the welding torch components.

Spools of welding wire are available from your CLARKE dealer.

1. Open the side panel by pushing the

latches down and allowing the side

panel to open.

2. Remove the locking nut and retaining

spring.

3. Place a spool of welding wire over the

spindle.

• DO NOT release the tension on the

wire, as it will unravel causing

feeding problems later.

• The wire will feed off the spool clockwise from the top of the reel.

• The spool must be fitted in the correct orientation otherwise it will not feed

correctly.

SETTING THE DRIVE ROLLER SIZE

1. Loosen the tensioning knob and pivot

it towards you.

2. Lift up the arm.

3. Take hold of the triangular knob on

the drive roller cover and rotate it

90°anticlockwise to release it.

4. Pull the roller retainer off the drive

spindle to reveal the roller.

5. Pull the roller off the drive spindle.

• The groove size is stamped on the corresponding side of the roller. Select

the groove size according to the size of the wire you are using and put the

roller back on the spindle with your chosen side facing you.

6. Replace the drive roller cover back onto the drive spindle with the opening facing

right.

WARNING: MAKE SURE THAT THE WELDER IS NOT CONNECTED TO

THE MAINS SUPPLY.

GWH3 Datasheet(PDF) 17 Page - Clarke International