SH7018 datasheet(378/431 Pages) RENESAS

378 / 431 page

362

16.11.2

Programmer Mode Operation

Table 16.11 shows how the different operating modes are set when using programmer mode, and

table 16.12 lists the commands used in programmer mode. Details of each mode are given below.

• Memory Read Mode

Memory read mode supports byte reads.

• Auto-Program Mode

Auto-program mode supports programming of 128 bytes at a time. Status polling is used to

confirm the end of auto-programming.

• Auto-Erase Mode

Auto-erase mode supports automatic erasing of the entire flash memory. Status polling is used

to confirm the end of auto-programming.

• Status Read Mode

Status polling is used for auto-programming and auto-erasing, and normal termination can be

confirmed by reading the I/O6 signal. In status read mode, error information is output if an

error occurs.

Table 16.11 Settings for Various Operating Modes In Programmer Mode

Pin Names

Mode

FWE

I/O0 to I/O7

A0 to A17

Read

H or L

Data output

Ain

Output disable

H or L

Hi-Z

Ain

Command write

H or L

Data input

*Ain

Chip disable

H or L

Hi-Z

Ain

Notes: 1. Chip disable is not a standby state; internally, it is an operation state.

2. *Ain indicates that there is also address input in auto-program mode.

3. For command writes in auto-program and auto-erase modes, input a high level to the

FWE pin.

SH7018 Datasheet(PDF) 378 Page - Renesas Technology Corp

SH7018 Datasheet(HTML) 378 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL