RX100 datasheet(38/71 Pages) RENESAS

38 / 71 page

Renesas Flash Programmer V2.04

CHAPTER 2 FUNCTION DETAILS (BASIC MODE)

R20UT2908EJ0100 Rev. 1.00

Page 38 of 71

Mar. 31, 2014

(4) [All Erase] command

This command is used to erase all blocks of the flash memory. The operation of the [All Erase] command is

subject to the setting of [Erasure Permission] of the [User Boot Area Options] category in the [Other Settings] tab of

the [Project Settings] dialog box. For details, see 2.4.3 (11) (f) <12>, [User Boot Area Options] category.

(5) [Program] command

This command is used to write the program file selected in the program file area to the flash memory. When

programming is complete, the result is displayed. The operation options related to the [Program] command are

according to the settings of [All Erase Before Program], [Verify After Program], [Checksum After Program],

[Security After Program], and [File Over Warning] in the [Command Options] category of the [Other Settings] tab in

the [Project Settings] dialog box. For details, see 2.4.3 (11) (f) <8> [Command Options] category.

Remark

When the [Program] command is executed, programming is performed after the block with data is

erased. To erase all blocks, set [All Erase Before Program] in the [Command Options] category in the

[Other Settings] tab of the [Project Settings] dialog box to “True.”

(6) [Verify] command

This command is used to verify that the data written to the flash memory is the same as the data in the program file

selected in the program file area.

RX100 Datasheet(PDF) 38 Page - Renesas Technology Corp