RX100 datasheet(60/71 Pages) RENESAS

60 / 71 page

Renesas Flash Programmer V2.04

CHAPTER 3 FUNCTION DETAILS (FULL MODE)

R20UT2908EJ0100 Rev. 1.00

Page 60 of 71

Mar. 31, 2014

3.4.4

[Help] menu

Clicking the [Help] menu displays the following pull-down menu. Refer to 2.4.4 for details of each menu.

Figure 3-6. [Help] Menu

3.5

Tool Bar

The tool bar lists the buttons for the commands of the [Microcontroller] menu. Clicking any of the buttons executes the

corresponding command. Some buttons become enabled or disabled depending on the settings.

Placing the mouse

cursor over a tool bar button displays a tooltip. Refer to 2.4.3 for details of each command.

Figure 3-7. Tool Bar

Table 3-1. Tool Bar

(1)

Executes the [Connect To Device].

(2)

Executes the [Disconnect To Device.

(3)

Executes the [Blank Check] command.

(4)

Executes the [Erase] command.

(5)

Executes the [All Erase] command.

(6)

Executes the [Program] command.

(7)

Executes the [Verify] command.

(8)

Executes the [Read] command.

(9)

Executes the [Set Security] command.

(10)

Executes the [Checksum] command.

(11)

Executes the [Get Flash options] command.

(12)

Opens a wizard-type dialog box for changing the project basic settings.

Remark: This button is invalid when the device is connected to a target

microcontroller. Select [Disconnect To Device] to enable the button.

(1) (2)

(3) (4) (5) (6) (7) (8) (9) (10)

(11)

(12)

RX100 Datasheet(PDF) 60 Page - Renesas Technology Corp

RX100 Datasheet(HTML) 60 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71

Datasheet Download

Link URL