AMD8513 datasheet(85/88 Pages) INFINEON

85 / 88 page

Data Sheet

Rev. 1.21, 2005-12-05

ADM8513

Data Sheet

Appendix Layout Guide

Trace routing

•

Keep USB differential pair data signal D+ and D-:

– Trace width should be as wide as possible.

– Make D+ and D- traces route at the same signal plane and not pass through the other plane.

– Inhibit crossover on D+ and D-

– The termination resistance (R2,R3) and decoupling capacitors (C1,C2) should be closed to ADM8513/X.

– D+ and D- Signal trace length should be equal and as short as possible.

•

Arrangement Tx and Rx trace

– Tx+/- and Rx+/- trace avoid right angle and round angle >90 degree, suggested.

– Trace width must be wide and should be wider than 8 mils.

– Signal trace length between Tx+/- differential pairs should be crossed and have equal length.The total length

should be no longer than 2 cm. The same requirement applies to Rx+/- also.

– Make Tx and Rx trace route at the same signal plane and not pass through the other plane.

– Every differential pairs as cross as possible, but no less than 8 mils and space should be almost equal.

– Keep space large between Tx and Rx differential pairs, even separated ground planes underneath Tx and

Rx signal pairs.

– Away from clock and power traces.

– If Tx routed trace must cross, the trace can be swapped between chip and transformer, and transformer to

RJ45,too.

Figure 9

Trace Routing 1

Figure 10

Trace Routing 2

•

Digital signal should be away from analog signal and Vcc traces. If you can't avoid this situation, analog signal

or Vcc trace should cross over 90 degree at other plane.

Bad

Good

AMD8513 Datasheet(PDF) 85 Page - Infineon Technologies AG