405EX datasheet(52/67 Pages) AMCC

52 / 67 page

PPC405EX – PowerPC 405EX Embedded Processor

AMCC Proprietary

Revision 1.09 - August 21, 2007

Preliminary Data Sheet

Spread Spectrum Clocking

Care must be taken if using a spread spectrum clock generator (SSCG) with the PPC405EX. This controller uses a

PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is called tracking

skew. The PLL bandwidth and phase angle determine how much tracking skew exists between the SSCG and the

PLL for a given frequency deviation and modulation frequency. If using an SSCG with the PPC405EX the following

conditions must be met:

• The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the

PPC405EX with one or more internal clocks at their maximum supported frequency, the SSCG can only lower

the frequency.

• The maximum frequency deviation must not exceed

−3%, and the modulation frequency must not exceed

40kHz. In some cases, on-board PPC405EX peripherals impose more stringent requirements (see Note 1).

• Use the peripheral bus clock for logic that is synchronous to the peripheral bus because this clock tracks the

modulation.

Notes:

1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of

approximately 1.5% on baud rate before framing errors begin to occur, assuming that the connected device is

running at precise baud rates. If an external serial clock is used, baud rate is unaffected by the modulation.

2. Ethernet operation is unaffected.

3. IIC operation is unaffected.

Caution: The system designer must ensure that any SSCG used with the PPC405EX meets these requirements

and does not adversely affect other aspects of the system.

405EX Datasheet(PDF) 52 Page - Applied Micro Circuits Corporation