| Electronic Components Datasheet Search |
|
TH3122KDF Datasheet(PDF) 4 Page - Melexis Microelectronic Systems |
|
|
|||||||||||||||||||||||||||||
TH3122KDF Datasheet(HTML) 4 Page - Melexis Microelectronic Systems |
|
4 / 14 page ![]() TH3122 K-Bus Transceiver with integrated Voltage Regulator Dec/04 Page 4 3901003122 Rev 004 Bit Compare If the signals at the pin TxD and the pin BUS within a specified time tbc are not identical, the transmission will be interrupted. If both signals at TxD and BUS are “High” within the time tena the transmission will be enabled. The bit-compare-function is active when the pin SEN/ STA is open (not overwritten). Regulator The TH3122 has an integrated linear regulator with an output voltage of 5V ± 2% and an output current of max. 100mA. The regulator is switched on or off with a signal on the EN pin or wakes up with a BUS signal. Initialization The initialization is started if the power supply is switched on, or after the temperature limitation has switched off the regulator or in case of BUS traffic (wake up). If the VCC voltage level is higher than VRESEIN, the reset time tRES is started. This reset time is determined by the Figure 5 - Bit Compare Pulse Diagram Using this pin as an input the transmission path can be overwritten (independent of bit-compare and constant-low function): SEN/STA=”0” forcing the transmission path free SEN/STA=”1” disable the transmission path Constant Low Switch Off A falling edge at pin TxD (from “1” to “0”) starts the internal constant low timer (SEN/STA open). If the low level “0” is valid for the time tlow the transmission unit of the TH3122 will be disabled. The receive unit is still active. A high level “1” at TxD with a minimum pulse width of trec resets the constant low timer. Transmitting is not possible until TxD and BUS is High for the time tena. TxD SEN/STA t low t ena t < t rec Figure 6 - Constant Low Pulse Diagram Linear Regulator and Controlling Functions SEN/STA The pin SEN/STA is bidirectional. Used as an output the pin indicates whether the transmit-path is enabled or disabled: SEN/STA =”0” transmission path is enabled SEN/STA =”1” transmission path is disabled voltage level on the VTR pin (see table VTR Programming). After tRES a rising edge on the RESET output is generated (see figure 7 - Initialization). The regulator is active and can only be switched off with a falling edge on EN. The regulator remains with EN=high in active mode and therefore the VCC voltage is also active. |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |